Analogy support 2g wiring vehicle gps tracker real time motorcycle gps tracker
MT200 this is multiple function which support 6wires.Analogy input support accessories,also I/O and door status detection inside this device.2G wired vehicle gps tracker suitable for all kinds of automotives.
Main features:
● Support GPS, AGPS and LBS, super-fast and accurate positioning
● Built in high sensitive G-sensor accelerometer
● Built in light sensor for removal alarm
● Driving behavior monitor (Speeding, hard declaration, hard acceleration, cornering alarm)
● 9-100 Wide voltage
● Support dual IP and dual protocols
● Support Kingwo,GT800 protocol and JT808 protocol , and protocol switch by SMS or Bluetooth setting
● Support upload interval by time, distance and speed
● Support OTA (Remote firmware upgrade feature)
● Bluetooth features for parameter setting and sensors connecting
Specification:
| Physical |
Dimension |
75*40*13mm |
| Weight |
45±3g |
| Cellular |
GSM module |
Quectel MC25 |
| Frequency |
Working Frequency: 850/900/1800/1900MHz
Network protocol: Embedded TCP/IP stack
Sensitivity: -107dBm@850/900MHz
-106dBm@1800/1900MHz
Output power: Class 4 (2W)@850/900MHz
Class 1 (1W)@1800/1900MHz
GPRS data: GPRS Class 10, Mobile Station Class B
|
| GPS |
Channels: 50
Sensitivity: -147dBm
Position accuracy:5-10m
Accuracy: 5m CEP
Cold start: <27s
Hot start: <1s
|
| Bluetooth |
Bluetooth 5.0 |
| Power |
Input voltage |
9-100V |
| Battery |
NI-MH AAA 3.6V/90mA,2hours working time based on 2-3 minutes upload |
| Power consumption |
Average Current: <30mA (DC 12V)
Maximum current: <10mA (DC 12V)
|
| Interface |
Digital input(2) |
Ignition detect and Air condition status detect |
| Digital output(1) |
Relay |
| Analog input 1 |
Voltage range:0-36V |
| GSM antenna |
Internal High Gain |
| GPS antenna |
Internal High Gain |
| SIM |
Microsim |
| Indicator |
2 status LEDs, Green: GPS, Red: GSM |
| Memory |
1000 packets |
| Environmental Parameter |
Working Temperature |
-20℃ ~ +70℃ |
| Humidity |
5% ~ 95% (no fog) |
| Ingress Protection Rating |
IP65 |
Functions:
1. Data upload according to time, speed and distance (Default setting is upload by time)
The device can be set to upload data packets to the backend at a certain time interval.
The device can be configured to send data packets at a certain distance
The device can be also configured to send data packets when it detects a certain speed change.
2. History data storage (Default ON)
When the vehicles enters the GPRS blind area, the device will store the GPS data upon 15s interval as default value, those data will be uploaded to the backend server once GPRS network recovered, maximum 1000 pcs of data can be stored, the interval can be configured from 5-7200 seconds
3. Cornering Compensation (Default ON)
If the device detects that the vehicle driving direction has certain angular deviation (default 15 degrees), the device will upload a packet extra to make sure the driving trace is more accurate.
4.LBS (Default OFF)
If GPS is not available, the device will automatically switch to LBS mode, and acquire the LBS each 30s and upload the LBS station IDs, the server shall interprets the specific location on the map, to use this function, it would require your server software support LBS function.
5. AGPS (Default ON)
The device supports AGPS, once the device is connected to GPRS, the AGPS can be used to speed up the positioning and improve accuracy,
Important notice: if your SIM card has IP access limitation, you may whitelist below IP for AGPS connection: 119.23.233.52
|
|
Analogy support 2g wiring vehicle gps tracker real time motorcycle gps tracker Images
|
